A full faired Suzuki Inazuma (GSR250F) is on the way
The GSR 250 F was introduced in Japan. The half faired version GSR 250 S and the naked variant GSR 250 will also be available.
The Suzuki GW250S (Inazuma S)
The Suzuki Inazuma S was introduced at the Shanghai motor show.
The higher handlebar and the new blue color along with the red one, are the most important changes noticed.
2013/4/1. More photos...
2013/3/30. Suzuki Motor Corporation will introduce the GW250S (Inazuma S) at the 15th Shanghai International Automobile Industry Exhibition which will be held from 20 April, 2013.
The GW250S, is an additional spec bike of the on-road motorcycle GW250, (Inazuma) which is being produced by SuzukiĘs joint venture in China, Changzhou Haojue Suzuki Motorcycle Co., LTD., and distributed in Europe, USA, Japan, China etc. By equipping a half-fairing, Suzuki claims that it gives a sportier image while increasing wind protection such as when riding on highways.
2012/11/4. ‘he Inazuma is a frugal twin cylinder 250 c.c. bike, featuring fuel injection (EFI) and disc brakes front and rear.
Concerning the price, its lower than the CBR250R and much lower than Kawasaki Ninja 250, in every country that has been announced. Thus wherever it has not been defined so far, it should be very close to that of Sym SB 250 Ni Wolf (‘2). This should be expected as the Inazuma is manufactured in China.
Performance data is 26 bhp/ 8,500 rpm, 2.5 kgm/ 7,000 rpm torque, while fuel consumption is 3.5 l/100km, (80 mpg Imperial), claimed figures. Two systems involved provide improved engine management. Suzuki Dual Throttle Valve (SDTV) in control of engine response and fuel combustion efficiency, while the Suzuki Exhaust Tuning (SET) is a servo-controlled butterfly enhancing low and mid rpm spectrum provided torque. The weight is increased, 180 kg (397 lbs) nominal kerb.
There is a delay concerning the sales around the world, however Suzuki has released a promotional video prior to the advent of Inazzuma. Some specifications are also given below.
Inazuma 250 Technical Specification
Engine capacity: 248cc
Engine: 4-stroke, 2-cylinder, liquid-cooled, SOHC
Bore: 53.5mm x 55.2mm
Compression ratio: 11.5:1
Ignition: Electronic (Transistorised)
Fuel system: Fuel Injection
Transmission: 6-speed constant mesh
DIMENSIONS AND WEIGHTS
Overall length: 2145mm
Overall width: 760mm
Overall height: 1075mm
Seat height: 780mm
Ground Clearance: 165mm
Kerb Weight: 180 Kg
Fuel capacity: 13.3litres
Front suspension: Telescopic, Coil spring, Oil damped
Rear suspension: Swing arm, Coil spring, Oil damped
Front brakes: Disc: 310 fully floating disc with two piston caliper
Rear brakes: Disc: 240 mm single disc with one piston caliper
Front tyres: 110/80-17M/C 57H
Rear tyres: 140/70-17M/C 66H